Meiko UPster U 400 Operating Instructions Manual page 34

Operating Instructions UPster U 400 / U 500 / U 500S
Par. Configuration
no. options
225 Detergent dosing
pump activation
mode
228 EW10 incorpo-
rated?
240 Detergent pump
activation mode
241 Air gap (FA) in-
corporated?
242 Drain pump (LP)
available?
243 Frost drainage
(without FA)
321 Final rinse pump
output
322 Detergent pump
output
326 Rinse aid vent
time
327 Detergent vent
time
346 Display LED2 or
LED1
347 Desinfection tem-
perature
348 Desinfection tem-
perature
9735077
Use as Value range Unit
Parameters 0 ... 4
Parameters 0/1
Parameters 0/1
Parameters 0/1
Parameters 0/1
Parameters 0/1
Parameters 0.1 ... 10
Parameters 0.1 ... 20
Parameters 0 ... 255
Parameters 0 ... 100
Parameters 0/1
Parameters 10 ... 80
Parameters 0 ... 90
Design and construction subject to change without prior notice
Page
Factory
setting
- 1 Definition energizing detergent
pump:
0 – no signal
1 – energizing according to calcu-
lated running time
2 - energize as final rinse
3 - activate as per wash pump
4 – Option – detergent pump using
negative pressure dosing ADT
- 0 or 1 In case of incorporated water sof-
tener set to 1
- 0 Effective only upon power supply
reset ON/OFF
Caution! All changes to service
parameters are reset.
Power supply reset must be car-
ried out within 5 minutes, other-
wise factory settings are not
loaded.
Without power supply reset, the in-
formation 123 will be displayed.
- 0 0: FA not available, final rinse over
Y1
1: FA available, plug connector
- 0 0: LP not incorporated
1: LP incorporated
- 0 0: no effect
1: Tank filling before Heating
l/h 1.3 Final rinse pump
Output definition.
l/h 8.5 Detergent pump
Output definition.
Sec. 180 Activate rinse agent pump tempo-
rarily to remove air from pipe.
Sec. 30 Activate detergent pump temporar-
ily to remove air from pipe.
- 1 0: LED2 with LEDs
1: LED1 with temperature display
°C 0 Only with disinfection machine
no.4 in parameter 201
10 sec. 0 Only with disinfection machine
no.4 in parameter 201
34 44
of
Note