Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Meiko M-iClean Series
Summary of Contents for Meiko M-iClean Series
- Page 1 Undercounter High Temperature Sanitizing Dishwasher (USA Version) ’ WNER NSTALLATION PERATION AND AINTENANCE ANUAL Models UM, UM+, US MEIKO • 1349 Heil Quaker Blvd. • La Vergne, TN 37086 • Phone: (615) 399-6600 • (800) 55-MEIKO • Fax: (615) 399-6620 Revised 3/17...
-
Page 2: Table Of Contents
ANY MODIFICATIONS TO THE APPLIANCE THAT ARE PERFORMED WITHOUT THE WRITTEN PERMISSION OF MEIKO WILL IMMEDIATELY VOID THE MANUFACTURER’S WARRANTY. MEIKO reserves the right to change any specifications without notice at any time. © 2017 MEIKO USA, Inc. All rights reserved. -
Page 3: Introduction
Pumped Final Rinse - An internal rinse pump ensures details on the customer, serial number and extent that the final rinse pressure is constant, for efficient of damage present. MEIKO will file a freight claim operation and consistent results. based on this information. -
Page 4: Installation
The area should be away from appliances, IMPORTANT furniture or surfaces that can be damaged by The appliance’s warranty is not valid until a MEIKO steam. If this is not possible, these items Authorized Service Agent performs a Startup and should be protected from the small quantities Demonstration on the appliance. -
Page 5: Uncrating, Positioning And Leveling
1-800-868-3840, providing full details on the customer, serial number and extent of damage Accessing the Utility Connections present. MEIKO will file a freight claim based on Utility connections are accessible on the lower rear of this information. the dishwasher. See Figure 3-1. In most cases, local 3. -
Page 6: Priming The Detergent And Rinse Aid Lines
IN ALL CASES, ANY ADJUSTMENTS OF THE FACTORY CHEMICAL INJECTION SETTINGS ARE TO BE PERFORMED ONLY BY A MEIKO AUTHORIZED SERVICE AGENT. CHANGES BY UNAUTHORIZED PERSONNEL WILL VOID YOUR WARRANTY. Press the... -
Page 7: Operation
4 - O ECTION PERATION PERATION Location and Description of Controls Figure 4-1: Dishwasher controls A - Wakeup key D - On/Off key Activates the machine from being turned off, This key is disabled withn the machine is fully turned activating the display and other controls. -
Page 8: Startup
4 - O ECTION PERATION Startup Loading Guidelines Check the level of the external detergent and rinse aid The loading guidelines shown here will lead to faster, dispensers. If necessary, replace or refill the dispensers. more efficient cleaning of your ware. Load plates, flat trays, etc. -
Page 9: Operation
4 - O ECTION PERATION Operation Interrupting a Wash Cycle If it is necessary to stop the cycle before it completes, press the key once, or slowly open the door. WARNING! If the door is opened suddenly, hot water can spray out of the dishwasher. -
Page 10: Low Detergent Indicator
4 - O ECTION PERATION Low Detergent Indicator Manual Water Change During regular operation, the M-iClean Filter removes The liquid detergent supply line ends in a detergent the majority of food soil particles from the water in the level detection sensor. If the sensor detects a low supply wash tank. -
Page 11: Cleaning
8. Wipe down the interior of the machine, and the inside of the door, using a soft cloth and warm water. 9. MEIKO recommends that the door of the dishwasher be left open overnight to allow it to air thoroughly. -
Page 12: Deliming (As Required)
Lime scale deposits will occur over time on the interior of the dishwasher. Deposits can be minimized by avoiding the use of a hard water supply. MEIKO recommends a hardness of 1-3 grains per U.S. gallon. To begin the deliming process, first ensure that the After the tank has filled, the display will prompt for the machine is turned off and fully drained. -
Page 13: Troubleshooting
1-800-868-3840 for assistance, or visit MEIKO’s website at www.meiko.us. Operating Issues (no messages) The issues shown below generally will NOT result in an error message. It may not be necessary to contact your MEIKO Authorized Service Agent if the listed action corrects the problem. Problem Action Machine does not fill OR •... - Page 14 6 - T ECTION ROUBLESHOOTING Message (in display) Problem Action Water loss in wash tank • Clear the message (see above). Daily water change, due to The machine had not been drained • At the end of the day, always shut down the wash tank being full for too in some time, and automatically machine using the automatic drain/shutdown cycle.
- Page 15 OTES _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _...
- Page 16 If you do not have the listing, visit MEIKO’s website at www.meiko.us, or call 1-800-868-3840 for assistance. MEIKO • 1349 Heil Quaker Blvd. • La Vergne, TN 37086 • Phone: (615) 399-6600 • (800) 55-MEIKO • Fax: (615) 399-6620 Revised 3/17...