Table of Contents
Advertisement
2-Pin Harness
Wire
Colour
BLUE/
1
WHITE
2
YELLOW
Flashing the Hood Pin Switch
Flashing the hood pin switch is a procedure that brings the system into programming mode. Once
the system is in programming mode, the installer will have up to 20 seconds to select one of the
sub-menus. if the installer fails to select a sub-menu before the 20-second delay, the system will
exit programming mode and the installer will have to flash the hood pin switch once more.
Tip: As long as the Hood is up, you may use the Programming Assistance Button instead of
the Hood Pin switch.
Here are the steps which the installer must follow in order to flash the Hood Pin switch:
1. Press and hold the Hood Pin switch for 4 seconds.
2. Release the Hood Pin switch.
3. While the Parking Lights are
Hood Pin switch once more.
4. Release the Hood Pin switch again.
Caution! If you press down and release the Hood
P. 8
When the user remote-starts the vehicle:
If no Glow-plug wire is found on the vehicle, the Glow-plug
input on the System may be "timed out". The System will
power up the Ignition and Glow-plug circuits and simply
wait for the time-out before starting:
Connect the Glow-plug wire to the Ignition wire only after
the Tach programming has been completed: connecting the
Glow-plug wire is one of the very last steps in the
installation process.
Function
This 500 mA negative output can be programmed for one of the
following Options:
(–)
1. Constant wh ile the
AUX 2
output
2. Pressing
(–) Parking
500 mA negative Parking Light output.
Light output
The Installer ...
, press down the
ON
• The System will power up the Ignition circuit and wait
to engage the Starter Motor while the Glow-plug
indicator light is still on.
• The System will engage the Starter Motor as soon as
the Glow-plug light (+) goes out.
o Minimum waiting time is 3 seconds.
o Maximum waiting time is 18 seconds.
• Connecting the Glow-plug input wire of the System to
Ignition will hold the ignition ON for the maximum
waiting time (18 sec., recommended).
• Keeping the Glow-plug input wire of the System
unconnected will hold the ignition ON for the
minimum waiting time (3 sec., not recommended in
very cold environments).
LOCK
simultaneously, + 1 sec. after the buttons are released.
and
LOCK
UNLOCK
and
with automatic toggle
ON
OFF
Description
and
buttons are pressed
UNLOCK
simultaneously toggles the output
after 30 seconds.
OFF
The Module ...
The Parking Lights will turn
The Parking Lights will stay
for 20 seconds
.
ON
ON
Installation Guide
Advertisement
Table of Contents
