Table of Contents
Advertisement
•
Within 3 seconds, press the
parking lights go out
To take the system o u t o f home valet mode:
•
Turn the ignition key to the
The system will warn you if someone attempts to start your vehicle while it stands in home valet
mode. The parking lights will:
Turbo Mode
If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode:
1. With the engine already running, press the
come
.
ON
2. Remove the ignition key from the ignition switch. The engine will go on running.
3. Exit the vehicle and close the door.
4. Press the
TRUNK
Mode.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
and hold the
LOCK
holding the buttons pressed until you hear another beep. At that point release the buttons. The
LED will toggle to its next state –i.e.: ON/OFF:
There are three programmable options regarding the flashing LED:
i.
The LED flashes once the starter kill is activated (passive or active arming) and will
turn itself off once the user turns the key to the
ii.
The LED is totally disabled and will not flash –it will turn on solid, however, when in
valet mode.
iii.
The LED will flash once the starter kill is activated but requires pressing the
button to turn itself off. Failure to press the
even if the key is in the
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle:
User Guide
IGNITION ON (RUN)
1- Turn
then
ON
OFF
2- Flash twice, pause; then
3- Flash twice again.
button to lock the doors; the engine will shut down after 60 seconds of Turbo
and
buttons on the transmitter. There will be an initial beep. Keep
UNLOCK
IGNITION ON
and
LOCK
START/STOP
position.
; then
button on the transmitter until the parking lights
LOCK
IGNITION ON
UNLOCK
position.
buttons simultaneously until the
position.
button will make the LED flash
UNLOCK
P. 9
Advertisement
Table of Contents
