Table of Contents
Advertisement
3
GREY
4
ORANGE
5
YELLOW
12-pin Accessories Harness
Wire
Colour
1
BLUE
2
BROWN
3
GREEN
WHITE /
4
BROWN
WHITE /
5
GREEN
BLUE /
6
WHITE
WHITE /
7
ORANGE
P. 6
Tachometer
in vehicles that use conventional coil systems. In Multi-coil systems,
input
the Tach wire may be difficult to locate: the negative terminal of an
injector may be used.
Note: a Tach-programming procedure must be carried out after the
installation is completed.
Connect this wire to the installed Hood Pin switch supplied. This
(–) Hood Switch
input will disable or shut down the Remote Starter when the Hood is
input
up, and can also set off the Alarm.
This wire must be connected to the Brake Light wire of the vehicle.
(+) Brake Switch
This wire must have +12 V only when the Brake Pedal is down.
input
This input will shut down the Remote Starter if the Brake Pedal is
pressed.
This wire provides a +12 V output and must be connected on the
vehicle to the Parking Lights wire that tests +12 V when the Light
(+) 12 V Parking
switch i s in the
Light output
Note: ensure that the voltage does not decrease or increase when
the dimmer control switch is turned. If the voltage goes up or down,
find another Parking Light wire.
Function
500 mA negative output. This output can be used to control
(–) Trunk /
the Trunk release (1-sec. pulse), or it can be set to operate
AUX 3
as a constant output as long as the TRUNK button is held
output
pressed (for Sunroof or Window closure)
(–) Lock
Programmable 500 mA negative output: 1/10-sec., 7/10-
output
sec. or 4-sec. pulse
Programmable 500 mA negative output: 1/10-sec., 7/10-
(–) Unlock
sec., 4 -sec. or double 1/4-sec. pulse ( O N 250 ms, OFF
output
500 ms, ON 250 ms).
500 mA ground signal when the Doors are locked by
remote control. This wire will go to ground 1/2 sec. before
the LOCK pulse, and go out 1/8 sec after LOCK. The wire
(–) Rearm
must be connected to the OEM Arm wire (usually the Door
output
Pin).
Note: The System will also give a Rearm pulse on this wire
when it shuts down the vehicle after a remote start.
500 mA ground pulse when the Doors are unlocked by
remote control. Connect to the OEM Disarm wire of the
(–) Disarm
vehicle.
output
Note: The system will also give a Disarm pulse on this wire
before every remote start.
This input should be used in vehicles with positive-
switching Door pins or Dome Light circuits. Connect to the
(+) Positive
Dome Light wire that tests +12 V when a Door is open.
Door input
Caution! The installer should use either the positive or the
negative Door input. Never use both of them
simultaneously.
(–) Starter Kill
This wire will provide a constant 500 mA output when the
output
system is armed (locked by remote control). It can be
(armed
connected to an external Starter Interrupt Relay.
output)
This wire should be connected to a Single Pole Double-
position.
ON
Description
Installation Guide
Advertisement
Table of Contents
