Table of Contents
Advertisement
1. Turn the Ignition Key to the
2. Within 3 seconds, press and release the Valet Button (the L.E.D. will come on and stay
lit).
The System must exit Valet Mode before a Transmitter Programming procedure can be
carried out:
Getting out of Valet Mode
1. Turn the Ignition Key to the
2. Within 3 seconds, press and release the Valet Button (the L.E.D. will go out)
(See section Valet Operation, in the User Guide, for more details on the use of Valet Mode.)
As the System exits Valet Mode, you will have 30 seconds to carry out the Transmitter
Programming procedure before the Alarm rearms.
The Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
– Before the lights go out, turn the Ignition Key to the
– Immediately turn the Ignition Key back to the
Press and hold the
5 times quickly and the siren will chirp twice.
– The System has stored the code of the Transmitter into memory.
2. To exit: close the Hood.
To program a Transmitter on the second vehicle for Multi-car Operation, you must press t h e
and
buttons simultaneously (instead of
TRUNK
LOCK
procedure.
Entering Programming Options Mode
The System is equipped with three custom programming Modes that allow the installer to custom-
fit the system outputs according to installation requirements. The Programming Options are
designed to facilitate interfacing with all vehicle types. (See section Table of Programming
Options later in this Guide.)
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights wi l l stay
– Before the lights go out:
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
•
LOCK
•
UNLOCK
•
TRUNK
The Parking Lights will flash and the Siren will chirp once, twice or three times to
confirm entry into a Mode.
3. Release the Brake Pedal.
Note
The Unit will stay in the selected programming Mode until the Hood Pin-switch or the
Brake Pedal is pressed again. Therefore take your time to make the proper
selection. Pressing the Brake Pedal will take you back to the Programming Centre,
where you can select a different Mode.
P. 10
IGNITION ON (RUN)
IGNITION ON (RUN)
button and keep it down until the Parking Lights flash
LOCK
Table 2: Programming a Transmitter
................to access Mode 1;
.............to access Mode 2;
...............to access Mode 3.
Table 3: Accessing modes
position.
position.
for up to 20 seconds.
ON
OFF
or
LOCK
UNLOCK
for up to 20 seconds.
ON
position.
IGNITION ON (RUN)
position.
) in transmitter programming
Installation Guide
Advertisement
Table of Contents
