Smart Secure Lock; Lock Pulse Duration; Engine Run Time; Open Zone Notification - Autostart AS-6010 TW-A Installation Manual

Hide thumbs Also See for AS-6010 TW-A:
Table of Contents

Advertisement

Smart Secure Lock

If the vehicle is initially locked, upon remote
disarm pulse before the Engine is started. The System will
running, and
once again 4 seconds after shut-down.
LOCK
If the vehicle is initially unlocked, upon remote
Starter Kill and Alarm, but the Doors will not be locked or unlocked at any moment of the
sequence.

Lock Pulse Duration

The duration of the Lock and Unlock pulses can be configured as follows:
(Default) 7/10-sec.
4-sec.
A single 7/10-sec.
for double-pulse disarm/unlock systems.
1/10-sec.

Engine Run Time

Use this Function to configure the length of time the Engine will be left running under remote
control. The System will allow the Engine to run for either 4, 15 or 25 min. in Gas Mode and 9, 20
or 30 min. in Diesel Mode. Standard default Run Time is 15 minutes in Gas mode and 20 minutes
in Diesel mode.

Open Zone Notification

This feature will warn the user when a Door is left open: upon the arming of the System, a 10-sec.
notification delay will take place, after which the Siren will chirp 3 times if an open door is detected.

Starter Kill (Installation)

The System is equipped with a selectable Passive or Active-arming Starter Kill circuit that will
prevent the vehicle from being started with the Ignition Key when the System is armed. The Starter
Kill wire will provide a constant 500-mA. negative output when the system is armed (locked by
remote control) and can be connected to an external Starter or Ignition interrupt relay.
The Starter Kill circuit follows the arming function of the Alarm and therefore can be set to arm in
either Passive Mode or Active Mode.

Passive or Active Arming

Active Arming: the Alarm and the Starter Kill will not arm automatically. Press the
button to arm and the
LOCK
Passive Arming: the Alarm and the Starter Kill will arm automatically if it is not armed
by remote within a 30-sec. delay. Press
Passive Arming without Siren Mute. Press
Disarmed Notification: See description below.

Disarmed Notification

This feature will notify the user when the vehicle is left disarmed: (1) after Ignition is turned off and
the Ignition Key is removed from the Ignition Switch, or (2) when the System is disarmed after
being previously armed, the opening or closing of a Door will start a 10-sec. timer, after which the
Horn or Siren will chirp once, if the vehicle was left unprotected, to warn the user. Pressing
or
before the 10-sec. delay elapses will cancel this warning.
UNLOCK
Installation Guide
and 7/10-sec.
LOCK
pulses to control vacuum Door Lock systems
LOCK/UNLOCK
pulse and two 1/4-sec.
LOCK
and 1/10-sec.
LOCK
the System will trigger an unlock pulse and a
START
the System will start the Engine and arm the
START
UNLOCK
pulses
UNLOCK
button to disarm it.
UNLOCK
UNLOCK
UNLOCK
again when the Engine is
LOCK
pulses
pulses
UNLOCK
to disarm.
to disarm.
LOCK
P. 17

Advertisement

Table of Contents
loading

Table of Contents