Remember; The Programming Assistance Button; Caution; Programming A Transmitter - Autostart AS-6010 TW-A Installation Manual

Hide thumbs Also See for AS-6010 TW-A:
Table of Contents

Advertisement

Pin Switch too many times, you will enter
Diagnostic Mode rather than Programming Mode.
5. You now have 20 seconds to select one of the sub-
menus.
Once the System has entered Programming Mode, you will have a selection of many different sub-
menus, which will be described later in this Guide:
a. Transmitter Programming
b. Programming Options
c. Honk/Horn Timing (if available)
d. Tach Programming

Remember:

Once the Parking Lights are
do not select a sub-menu within 20 seconds, the System will exit Programming Mode and you will
have to flash the Hood Pin switch once again.

The Programming Assistance Button

(A.k.a. the PAB.) Mounted on the System, this
button can be used from within the vehicle
instead of the Hood Pin switch in the Engine
compartment. This will spare the installer the
trouble of accessing the Hood Pin switch in the
Engine compartment.

Caution

The Hood Pin switch must be installed and connec ted in order for the Programming
Assistance Button to function. The button will work only when the Hood is up.

Programming a Transmitter

Before you Proceed

The Transmitter of the System is not delivered pre-programmed: it must be programmed after the
wiring of the System is completed. The System has the ability to retain up to 4 different Transmitter
codes; if a fifth Transmitter is programmed, the code of the first Transmitter will be lost from
memory. To erase all Transmitter codes from memory, you must perform a reset of the
System (see Resetting the System, later in this Guide, for more details).

A Word of Caution About the Alarm

The Alarm is triggered when the Unit is powered up because the default state of the Alarm is
. You will therefore need to shut off the Alarm before you carry out the Transmitter
ARMED
Programming procedure.
One way to shut off the Alarm is to (1) set the System to Valet Mode and then (2) immediately set
the System out of Valet Mode. (See instructions below.)
Getting into Valet Mode
Installation Guide
Table 1: Flashing the Hood Pin switch
(solid), you have up to 20 seconds to select a sub-menu. If you
ON
P. 9

Advertisement

Table of Contents
loading

Table of Contents