Table of Contents
Advertisement
Siren Mute
When the Siren is sounding, pressing the
unlock or disarm the vehicle.
Horn / Siren Mode
The System can be configured to use either the Siren or the Horn for sound signals and alarms.
Siren or Horn Chirps
The Siren can be configured to give the following signals:
Warning Chirps:
Arming and disarming the car (
the vehicle is being armed, the Siren will chirp 3 times if a Zone is active. After the
Alarm is set off, disarming the vehicle will cause the Siren to chirp 4 times.
Full Chirps:
Pressing the
• cause the Siren to chirp 1 time if all Zones are inactive.
• cause the Siren to chirp 3 times if a Zone is active.
Pressing the
• if no intrusion was detected, the Siren will chirp 2 times.
• if an intrusion was detected, the Siren will chirp 4 times.
Open Zone Notification (see below):
If a Door is detected as open 10 sec. after arming, the Siren will chirp 3 times.
Chirps disabled: the Siren will not chirp under any circumstance.
Shock Sense and Warn-away Sense
Your System can react to a full shock by triggering the Alarm; it can also respond to a lighter shock
(30 % of the strength of a full shock) by giving a Warn-away: the Siren will chirp but no Alarm
condition will be triggered. However, when the Engine is running after a remote start, the Shock
Sensor will not trigger an Alarm condition, although it will still produce warning chirps if Warn-
away Sense is enabled.
Note
Although the Shock Sensor may not trigger an Alarm condition after remote starts, the
Door Zones and the Hood Pin-switch may generate one: the Door Zones and the
Hood Pin-switch are not disabled in any way after remote starts.
Resetting the System
The system is equipped with a reset function that allows the installer to erase all transmitter codes
from memory and return all the programming options to the factory default values. Resetting the
system is not a required process. Most of the time, you can avoid resetting by fixing the i s sue
directly at the root of the cause.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2. Press and release the Break Pedal 6 times (within 13 seconds from entering
Programming Mode).
3. The Parking Lights will flash 8 times to confirm resetting.
P. 18
UNLOCK
LOCK
button will lock all Doors, arm the system and
LOCK
button will unlock and disarm the vehicle and:
UNLOCK
Table 8: Resetting without a Valet Button
button will stop the Siren. Note that this will not
or
) will not cause the Siren to chirp. While
UNLOCK
Installation Guide
Advertisement
Table of Contents
