1. Manuals
  2. Brands
  3. Autostart Manuals
  4. Remote Starter
  5. AS-6250V
  6. User manual

Autostart AS-6250V User Manual

One-way automatic/manual transmission remote starter with full alarm system
Hide thumbs Also See for AS-6250V:
Table of Contents

Advertisement

Quick Links

Download this manual
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
DOC. 1.00
- AS-6250v -
O N E - W A Y
A U T O M A T I C / M A N U A L
T R A N S M I S S I O N
W I T H
F U L L
AS-6250v
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1.
a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled
or put into valet mode before servicing.
- August 28, 2007 -
R E M O T E
S T A R T E R
A L A R M
S Y S T E M
WARNING
- MO -
Assembled in Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AS-6250V and is the answer not in the manual?

Questions and answers

Related Manuals for Autostart AS-6250V

Summary of Contents for Autostart AS-6250V

  • Page 1 (Note: Make sure that the automatic vehicle cannot start in "Drive".) 2. It is the user's responsibility to ensure that the remote starter is disabled or put into valet mode before servicing. FCC USER NOTICE (U.S.A.): This device complies with Part 15 of the FCC Rules.

  • Page 2: Table Of Contents

    Transmitter Part Number and Module Serial Number... 3 Introduction ... 3 Basic Remote Operation ... 4 Remote-starting Your Vehicle ... 4 Setting Your Vehicle into Ready Mode ... 4 Remote-starting ... 4 Vehicle Presets... 4 Heater & Heated Seat ... 4 Windshield Wipers &...

  • Page 3: Number

    Transmitter Part Number and Module Serial Number Transmitter Part Number: The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located (if installed): Introduction This Module is a state-of-the-art combination of an Alarm system and a remote car starter.

  • Page 4: Basic Remote Operation

    Basic Remote Operation This system is equipped with a 5-button multi-channel transmitter. It can operate two in- dependent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions of the transmitter are as follows: LOCK: Locks the doors and arms the STARTER KILL.

  • Page 5: Remote-Starting

    This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. For example, if you stop for a User Guide quickly and remain lit.

  • Page 6: Valet Modes

    delivery or at a convenience store, lock your vehicle and leave it running for the length of a run cycle while you are away. To leave the vehicle in Idle Mode if your vehicle has an automatic transmission: With the engine running, press the or the button on the remote control until the parking lights come on.

  • Page 7: Ignition Valet

    This feature will put your vehicle into Valet Mode using the remote transmitter instead of the Valet button as above. Note: Once the Electronic Valet is activated, the remote starter and Alarm features are disabled. To put the system into Valet Mode: 1.

  • Page 8: Panic Mode

    4. Flash twice again. Panic Mode Safety feature: Activate Panic Mode in an emergency situation. In an emergency situation, you can activate Panic Mode using the button. This will: Shut down the engine, Unlock the doors (if UNLOCK pressed) Or lock the door (if LOCK To activate Panic Mode Press and hold the...

  • Page 9: Priority Door Access

    Priority Door Access This safety feature lets you unlock only the driver’s door when you press the button on the transmitter, and then button is pressed for a second time within 3 seconds. Chirp Delete To temporarily disable the siren’s chirp confirmations upon arming and disarming (e.g. in a quiet neighbourhood): 1.

  • Page 10: Remote Door Locks

    Remote Door Locks If your system was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. your doors and UNLOCK Press and hold the The parking lights will flash twice and the LED will go out to confirm that the doors have been unlocked, that the Starter Kill feature is disarmed (if it was installed) and that the Alarm is disabled.

  • Page 11: Open Zone Notification

    Open Zone Notification (the system will warn for doors opened up to 10 seconds after arming). No Chirp (the vehicle will not chirp under any circumstance). Open Zone Notification (Off by default.) This feature will warn the user when a Door is left open: upon the arming of the Module, a 10-sec.

  • Page 12: Engine Run Time

    If your vehicle has an automatic transmission, proceed as follows to set the system in Turbo Mode: With the engine already running, press the the parking lights come Remove the ignition key from the ignition switch. The engine will go on running.

  • Page 13: Multi-Car Operation

    Multi-Car Operation This option allows the owner of two vehicles, both equipped with identical systems, to control both systems with only one remote transmitter. To control the second vehicle, simultaneously press the Press button simultaneously: TRUNK LOCK Press TRUNK UNLOCK Press TRUNK START...

  • Page 14: Parking Lights Flash Rate

    Parking Lights Flash Rate (Normal Operation) Flashes • Doors locked, Alarm and starter kill armed. • Run time has expired. • TRUNK • Remote start attempt cancelled by remote. • Doors unlocked, starter kill disarmed. • Exiting ignition valet • Power ON to OFF(Automatic transmission) 2 slow flashes then •...

  • Page 15: Limited Lifetime Warranty

    In all cases, the consumer must return the remote starter module to the point of purchase, and must provide a copy of the proof of purchase to said retailer. A remote starter module will be returned to the retailer for the consumer to claim within a 4 (four)-week period.

Table of Contents

Save PDF