Supplementary Information; Fifth Relay Output (2 Crank); Nd Ign, Acc Or; Caution - Autostart AS-6010 TW-A Installation Manual

Supplementary Information

Fifth Relay Output (2

Caution!

Only one set of pins can be used at one time. Using more than one Jumper may result in
serious damage to the vehicle.
The relay output rating on this unit is 25 A at most. Defective OEM solenoid switches can
sometimes draw up to 50 or 60 A, causing the 30 A Fuse to blow. Always verify your circuit
with an appropriate measuring device.

Ignition-controlled Door Locks

This feature will
LOCK
Ignition Key is in the
is turned back to the
If Ignition Lock Only is selected, the system will only
pressed while the Ignition Key is in the
If option Ignition Unlock Only is selected, the system will
to the position (provided that the Ignition key was in the
OFF
Brake Pedal was pressed at least once).

Ignition Re-lock

This feature is automatically available whenever Ignition Lock is available. When Ignition is
(but not under remote start) and a Door is opened and closed, the system will re-lock all doors next
time the Brake Pedal is pressed.

Secure Lock

This feature allows the System to control certain OEM factory Alarm systems without requiring the
use of other wires for disarming the OEM Alarm. (Namely, this feature is designed for OEM
systems which use the factory Lock wire to arm the Alarm and the Unlock wire to disarm it.)

Standard Secure Lock

If this Option is selected, upon receiving a remote
(disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will re-lock the Doors. 4
seconds after shutdown, Secure Lock will re-lock all Doors (arming the system once again).
Please note that most OEM systems will not rearm the Alarm while the Engine is running, but will
still lock the Doors.
P. 16
nd IGN, ACC or CRANK)
all the Doors of the vehicle when the Brake Pedal is pressed while the
position. The unit will
IGNITION ON (RUN)
position.
OFF
IGNITION ON (RUN)
Systems of this series are equipped with an
on-board high-current programmable 5
Relay that can be used to power a second
Ignition, Accessory or Crank wire.
The Unit uses 3 sets of pins; each set
corresponds to a s pecific function of the
output. In order to activate one of the three
possible functions, you must place the
Jumper (supplied) on one of the three sets
of pins and connect the 14 AWG wire to the
second IGN. / ACC. / CRANK wire of the
vehicle.
all Doors when the Ignition Key
UNLOCK
all Doors when the Brake Pedal is
LOCK
position.
all Doors when the key is turned
UNLOCK
IGNITION ON (RUN)
signal, Secure Lock will
START
position and that the
ON
the Doors
UNLOCK
Installation Guide
th