Flashing The Hood Pin; Tach Programming - Autostart AS-1414 Installation Manual

Flashing the Hood Pin

What is Flashing the Hood Pin?
It is a procedure that makes the module go into the programming centre. Once the module is
in the programming centre, the installer has no more than 20 seconds to get into one of the
sub-menus. Failure to do so will result in the module exiting the programming centre
and the installer will have to flash the hood pin once more.
Remember
: You can use the Programming Assistance Button
(PAB) instead of the Hood Pin any time the Hood is up.
1. Press and hold the hood pin for 4 seconds.
2. Let go of the hood pin.
3. While the parking lights are on, press down the hood pin
once more.
4. Release the hood pin again.
5. You now have 20 seconds to select one of the sub-menus.
Once inside the programming centre, the Installer has a selection of many different sub-
menus. Once you are in the programming centre, you have the option of the following
menus:
Remember:
You have up to 20 seconds, once the parking lights are on solid, to select a sub-
menu, Failure to do so will result in the module exiting the programming centre and the installer
will have to flash the hood pin once more.
P. 8
If no glow plug wire is found on the vehicle, the glow
plug input on the module may be "timed out". The
module will power up the ignition and glow plug circuits
and simply wait for the time-out before starting:
Connecting the glow plug input wire of the module to
ignition will hold the ignition
waiting time (25 sec., recommended).
Keeping the glow plug input wire of the module
unconnected will hold the ignition
waiting time (3 sec., not recommended in very cold
environments).
Connect the glow plug wire to the ignition wire only after
tach has been programmed (i.e.: Connecting the glow
plug wire is one of the very last steps in the installation
process.
The Installer ...
a) Transmitter Programming .......................
b) Programming Options ..........................
c) Honk Horn Timing* (*if available) ..............
d)

Tach Programming ................................

Minimum waiting time is 3 seconds.
•
Maximum waiting time is 25 seconds (approx).
•
Installation Guide
for the maximum
ON
for the minimum
ON
The Module ...
Parking Lights "ON"
"ON" for 20 seconds
p.9
p.10
p.11
p.11
AS-1414/ AS-1424