Table of Contents
Advertisement
on some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the
brake pedal is pressed while the ignition key is not in the
therefore to hot-wire the brake pedal by manually jumping 12 V with a fused test lead at the brake
pedal switch.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2. Press and release the Valet Button 6 times or more until the Parking Lights start to
flash.
3. The Parking Lights will flash 8 times to confirm resetting.
Events Logging
With this feature, the System wi l l play back the last 4 Start Failure Events Codes and the
last Intrusion Code via the Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
.
OFF
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push the Pin-switch 3 more times
(down-up / down-up / down-up).
The Parking Lights and L.E.D. will flash the five events stored in memory.
The first four playback codes are start failure events, while the last playback code is an intrusion
code. There is a pause after each event code is played back. The system will play back the most
recent event first, then the sec ond one, and so on. if there is no event at all to report, the parking
lights will give one long flash. To jump directly the intrusion code, press the brake pedal. Close the
hood to end playback.
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
Intrusion Codes
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead...
2 x = Doors intrusion
Intrusion Codes through the LED Light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will provide an
intrusion code matching the type of the intrusion which took place. The LED intrusion codes are
flashed in continuous loops, using the same codes as those provided during Events Playback:
Installation Guide
Table 9: Resetting with the Valet Button
Table 10: Events playback
Note: "x" stands for one flash of the Parking Lights
I GNITION ON (RUN)
6 x = Hood
7 x = Engine Running, no Ignition detected,
or Tach before Start
10x = Alarm condition
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
position: you will need
P. 19
Advertisement
Table of Contents
