Table of Contents
Advertisement
12
YELLOW
2-Pin Harness
Wire
Colour
BLUE/
1
WHITE
YELLO
2
W
Flashing the Hood-Pin Switch
Flashing the hood-pin switch is a procedure that brings the module into programming
mode. Once the module is in programming mode, the installer will have a maximum of
20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the module will exit the programming mode and the installer
will have to flash the hood pin switch once more.
Tip
As long as the hood is up, you may use the
programming assistance button instead of the hood-
pin switch.
P. 12
• Connecting the glow-plug input wire of the
module to ignition will hold the ignition ON for
the maximum waiting time (15 seconds
recommended)
• Keeping the module's glow-plug input wire
(+) Glow-Plug
unconnected will hold the ignition ON for the
input
minimum waiting time (3 sec., not recommended
(cont.)
in very cold environments).
Connect the glow-plug wire to the ignition wire only
after the tach programming has been completed:
connecting the glow-plug wire is one of the very last
steps in the installation process.
Function
This 500 mA negative output can be programmed
for one of the following Options:
1. Constant while the
LOCK
(–) AUX 2
released.
output
2. Pressing
simultaneously toggles the output ON and
OFF with automatic toggle OFF after 30
seconds.
500 mA negative parking light output
Note: Ensure that the voltage does not vary
(–) Parking
when the dimmer control switch is turned up or
Light
down. If this is the case, it is not the right wire.
output
There is also a positive parking light output.
Only one of these two different outputs needs
to be connected.
Description
button followed by the
SHIFT
button, + 1 sec. after the buttons are
button followed by the
SHIFT
Installation Guide AS-2360TW
LOCK
Advertisement
Table of Contents
