Flashing The Hood Pin Switch; Tip; Remember - Autostart AS-2510 TW Installation Manual

Flashing the Hood Pin Switch

Flashing the Hood Pin switch is a procedure that brings the Remote Car Starter into
Programming Mode. Once the Remote Car Starter is in Programming Mode, the installer
will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a
sub-menu before the 20-second delay, the Remote Car Starter will exit Programming Mode
and the installer will have to flash the Hood Pin switch once more.

Tip

As long as the Hood is up, you may use the
Programming Assistance Button instead of the
Hood Pin switch.
Here are the steps which the installer must follow in order to flash the Hood Pin switch:
The Installer ...
1. Press and hold the Hood Pin switch for 4 seconds.
2. Release the Hood Pin switch.
3. While the Parking Lights are
Hood Pin switch once more.
4. Release the Hood Pin switch again.
Caution! If you press down and release the Hood
Pin Switch too many times, you will enter
Diagnostic Mode rather than Programming Mode.
5. You now have 20 seconds to select one of the sub-
menus.
Once the Remote Car Starter has entered Programming Mode, you will have a selection of
many different sub-menus, which will be described later in this Guide:
a. Transmitter Programming
b. Programming Options
c. Honk/Horn Timing (if available)
d. Tach Programming

Remember:

Once the Parking Lights are
up to 20 seconds to select a sub-menu. If you do
not select a sub-menu within 20 seconds, the
Remote Car Starter will exit Programming Mode
and you will have to flash the Hood Pin switch
once again.
AS-2510 TW Installation Guide
, press down the
ON
Table 1: Flashing the Hood Pin switch
(solid), you have
ON
The Module ...
The Parking Lights will turn
ON
The Parking Lights will stay
for 20 seconds
P. 9
.
ON