Eaton EDR 3000 Installation, Operation And Maintenance Manual page 239

How to set up the Fault Recorder
The » Record-Mode« will determine if trips only cause a fault record or if also Alarms without a consecutively trip should
cause a fault record. This parameter is to be set within menu [Device Para\Recorders\Fault rec]
How to navigate within the Fault Recorder
How to read Out the Fault Recorder
In order to read out a fault record there are two options available:
Option 1: A Fault has popped up on the HMI (because an trip or pickup has occurred).
•
Option 2: Call up manually the Fault recorder menu.
•
Option 1 (in case a fault record pops up on the display (overlay):
Analyze the fault record by using Softkeys Arrow Up and Arrow Down.
Or close the Popup by using Softkey OK
Option 2 :
Call up the main menu;
Call up the sub-menu »Operation/Recorders/Fault rec.«;
Select a fault record; and
Analyze the fault record by using Softkeys Arrow Up and Arrow Down.
Navigation within the
Fault recorder
Back to overview.
Next (upper) item within this
fault record.
Previous fault record.
Next (lower) item within this
fault record.
www.eaton.com
EDR-3000
Softkey
IM02602003E
227