Setting Up The Housing; Preparing The Camera; Preparing The Housing - Fantasea Line FG7X Instruction Manual

Housing for canon powershot g7 x
Table of Contents

Advertisement

SETTING UP THE HOUSING

Note

PREPARING THE CAMERA

1. Install a (preferably empty) memory card (16 GB+ capacity recommended) and a fully charged
battery inside the camera.
2. Remove the camera strap from the camera if one was installed.
3. Rotate the Mode Dial so the Auto shooting mode is selected and aligned with the white mark on
the left of the wheel. This will allow for the camera and housing mode dials to be aligned, so the
housing mode dial will indicate the proper mode selected by the camera dial.
4. It is recommended to program the camera to the most frequently used underwater photo mode,
lighting and other key settings prior to installing the camera in the housing.

PREPARING THE HOUSING

1. When using the housing for the first time-
a. Peel the transparent plastic screen protector off the back door exterior of the housing.
b. Install the hand lanyard on the housing by inserting it through the lanyard loop on the
bottom right of the housing (facing from back), then pulling it through itself and testing it
in order to make sure it is secure (image #1 on the following page).
c. Install the housing side of the diffuser quick release tether by tying it around the lower
rectangular loop at the bottom left side of the housing (image #2 on the following page).
Please note that this line may come assembled, in which case there is no need for
installation.
d. Open the housing (see section "Opening the Housing" on the following page) and remove
the anti-glare hood out of the housing. Secure the anti-glare hood to the housing by tying
its tether around the lower rectangular loop at the bottom left side of the housing. Install
the anti-glare hood over the anti-glare hood rails at the back of the housing. First install
It is important that a first dive is always carried out with the housing
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been affected during transport and after long
periods of storage.
FG7X Housing Instruction Manual 20150101
12

Advertisement

Table of Contents
loading

Table of Contents