Automatic / Non-Automatic Start Mode - Julabo F25-MC Operating Manual

Operating procedures
6.3.

Automatic / non-automatic start mode

Warning:
For supervised or unsupervised operation with the AUTOSTART
function, avoid any hazardous situation to persons or property.
The circulator does no longer conform to N.A.M.U.R.
recommendations.
Take care you fully observe the safety and warning functions of the
circulator.
30
AUTOSTART ON / OFF
Keep depressed enter
and turn on the circulator with the mains power switch.
For a short while the MULTI-DISPLAY indicates the effective
start mode:
AUTOSTART on.
AUTOSTART off.
NOTE:
The circulator has been configured and supplied by JULABO
according to N.A.M.U.R. recommendations. This means for
the start mode, that the unit must enter a safe operating state
after a power failure (non-automatic start mode). This safe
operating state is indicated by „OFF" or „rOFF", resp. on the
MULTI-DISPLAY (LED). A complete shutdown of the main
functional elements such as heater and circulation pump is
effected simultaneously.
Should such a safety standard not be required, the
AUTOSTART function (automatic start mode) may be
activated, thus allowing the start of the circulator directly by
pressing the mains power switch or using a timer.
and the start/stop key