Bath Fluids - Julabo F25-MC Operating Manual

Preparations
5.2.

Bath fluids

Caution:
Carefully read the safety data sheet of the bath fluid used, particularly
with regard to the fire point!
If a bath fluid with a fire point of ≤65 °C is used, only supervised
operation is possible.
Water:
The quality of water depends on local conditions.
•
•
•
•
Recommended bath fluids:
Caution:
Fire or other dangers when using bath fluids that are not
recommended:
Please contact JULABO before using other than recommended bath
fluids.
Use only nonacidic and noncorrosive bath fluids.
JULABO assumes no liability for damage caused by the selection of an
unsuitable bath liquid.
Unsuitable bath fluids are fluids which, e.g.,
• are highly viscous
• have a low viscosity and have creep characteristics
• have corrosive characteristics or
• tend to crack.
• No liability for use of other bath fluids!
24
Due to the high concentration of lime, hard water is not suitable for
temperature control because it leads to calcification in the bath.
Ferrous water can cause corrosion - even on stainless steel.
Chloric water can cause pitting corrosion.
Distilled and deionized water is unsuitable. Their special properties
cause corrosion in the bath, even in stainless steel.
Bath fluid
soft/decalcified water
See website for list of recommended bath fluids.
Contact: see page 6
(much higher than 50 mm
temperature)
Temperature range
2 -1
x s at the respective working
5 °C to 80 °C