Safety Messages (Review Carefully) - HID FARGO DTC1250E User Manual

4.1.1.4 Safety Messages (Review Carefully)

Note: All messages are provided in English and French.
Symbol
Page 4-6
Printer Preferences
Critical Instructions for Safety Purposes
Danger:
Failure to follow these installation guidelines can result in death or serious injury.
Information that raises potential safety issues is indicated by a warning symbol (as shown to
the left).
• To prevent personal injury, refer to the following safety messages before performing an
operation preceded by this symbol.
• To prevent personal injury, always remove the power cord prior to performing repair
procedures, unless otherwise specified.
• To prevent personal injury, make sure only qualified personnel perform these
procedures.
Attention:
Le non respect de ces consignes d'installation peut entraîner la mort ou des blessures graves.
L'information qui pose des problèmes de sécurité potentiels sont signalées par un symbole
d'avertissement (comme illustré à gauche).
• Pour éviter toute blessure, consultez les consignes de sécurité suivantes avant
d'effectuer une opération précédée par ce symbole.
• Pour éviter toute blessure, débranchez toujours le cordon d'alimentation avant
d'effectuer les procédures de réparation, sauf indication contraire.
• Pour éviter toute blessure, assurez-vous que seul le personnel qualifié est chargé de ces
procédures.
Caution:
This device is electrostatically sensitive. It may be damaged if exposed to static electricity
discharges.
Information that raises potential electrostatic safety issues is indicated by a warning symbol
(as shown to the left).
• To prevent equipment or media damage, refer to the following safety messages before
performing an operation preceded by this symbol.
• To prevent equipment or media damage, observe all established Electrostatic Discharge
(ESD) procedures while handling cables in or near the circuit board and printhead
assemblies.
• To prevent equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove the Ribbon and Cards from the
Printer before making any repairs, unless otherwise specified.
• To prevent equipment or media damage, take jewelery off of fingers and hands, as well
as thoroughly clean hands to remove oil and debris before working on the printer.
PLT-01668, Version: 1.2
December 2016