Omron 8025G Maintenance Manual page 33

INSTALLATION AND CHECKOUT
SECTION 2
Figure 2-6 shows the correct routing of all flat-line interconnect cables in
the terminal. Cable routing is as follows:
1) The cable on the far right (a l6-conductor flat-line) connects the
Printer RS-232 Interface Card to J203, mounted on the rear panel of
the terminal.
2) The second cable from the right (a l6-conductor flat-line) connects
the Auxiliary Storage RS-232 Interface Card to J202, mounted on the
rear panel of the terminal.
3) The next card, the Communications (Modern) RS-232 Interface Card, has
two cables. A l4-conductor flat-line (top-connector) connects it to
the Baud Rate Switch mounted on the rear. panel of the terminal. A
l6-conductor flat-line (just below the Baud Rate cabte) connects the
card to J201 mounted on the rear panel of the terminal.
4) The cable on the far left (a l6-conductor flat-line) connects the
Cursor Control Card to the keyboard. This cable is routed along the
right side of the terminal (viewed from front).
5) The cable running to the top of the photo (a l6-conductor flat-line)
connects the Video Control Card to the Monitor Deflection Board.
6) The remaining cable (a l4-conductor flat-line) connects the Refresh
Buffer Card to the keyboard indicator lights. This cable is routed
along the right side of the terminal (viewed from front).
Figure 2-6. Flat cable connections.
2-5