Setting The Dhcp Server - Oki MC853 User Manual

Setting the DHCP Server

DHCP assigns an IP address to each host on a TCP/IP network.
Note
To print via a network, this machine must have an IP address. For details on how to assign a
static IP address, refer to the manual of your DHCP server.
Memo
The following procedure is explained using Windows Server 2008 R2 as an example. The steps
and menus may vary depending on your operation system.
1.
Click [Start], and then select [Administrative Tools] > [Server
Manager].
If [DHCP] is already displayed in [Administrative Tools], proceed to step 8.
2.
Select [Add Roles] from [Roles Summary].
3.
Click [Next] in [Add Roles Wizard].
4.
Select the [DHCP Server] check box, and then click [Next].
5.
Set the settings by following the on-screen instructions, if
necessary.
6.
Check the setting on the [Confirm Installation Selection] screen,
and then click [Install].
7.
When the installation is complete, click [Close].
8.
Click [Start], and then select [Administrative Tools] > [DHCP] to
start the [DHCP] wizard.
9.
Select a server to use from the DHCP list.
10.
Select [New Scope] from the [Action] menu.
11.
Set the settings by following the on-screen instructions in [New
Scope Wizard] if necessary.
Memo
Be sure to set the default gateway.
Select [Yes, I want to activate the scope now] on the [Active Scope] screen.
1111