Selecting A Sensor For Configuration - Omron FQ-CR2 User Manual

3-1 Selecting a Sensor for Configuration

If multiple Sensors are connected to a single Touch Finder or computer, you can select the Sensor that you
want to set up.
1
Press [Run].
This will enable setting the current Sensor into RUN
Mode before selecting another Sensor.
2
Then press [Switch to Run mode].
3
Press [Yes].
4 − [Switch Sensor].
Press
5
Press the image of the Sensor to be set up.
will be displayed for Sensors that are not yet set.
Note
Once the Touch Finder detects and records a Sensor, the display or-
der for showing more than one Sensor is fixed. Even if the system
configuration is changed to reduce the number of Sensors, the pre-
vious display location will remain for Sensors that were removed.
To update displays of multiple Sensors to the current connection sta-
tus, press [ ] - [Auto connect] on the right of the display in step 5,
above, to automatically reconnect.
6
Press
Mode.
7
Press [Yes].
34

Selecting a Sensor for Configuration

− [Sensor settings] to return to Setup
FQ-CR2 User's Manual