Error Messages - Omron FQ-CR2 User Manual

Checking the Error Histories
• Checking the History of Errors That Have Occurred in the Sensor
(Setup Mode) − [Sensor settings] − [Error history] − [View history]
Errors will be displayed in order with the most recent ones on
top.
• Checking the Log of Errors That Have Occurred in the Touch Finder
(Setup Mode or Run Mode) − [TF settings] − [Error history] − [View history]
Clearing the Error Histories
• Deleting the History of Errors That Were Detected in the Sensor
(Setup Mode) − [Sensor settings] − [Error history] − [Delete history]
• Deleting the History of Errors That Were Detected in the Touch Finder
(Setup Mode or Run Mode) − [TF settings] − [Error history] − [Delete history]
Note
Refer to the following information for the measures to take when errors occur.
Errors Stored in the Error History: p. 154
Checking the Latest Error Information (for No-protocol Connection to Ethernet)
The error code of the latest error can be acquired as a response using the error information acquisition
command (ERRGET).
• Error Codes: p. 154
• Error Information Acquisition Command (ERRGET): p. 146

Error Messages

If an error occurs while making settings on the Touch Finder, an error message will appear on the display.
For these errors, the ERR indicator on the Sensor will not light, the ERROR signal will not be output, and the
error will not be recorded in the error history.
Follow the instructions that are given in the error message.
If the following messages appear, the hardware may be faulty.
Contact your OMRON representative.
• System error.
• Application system error. Please reboot.
• Failed to startup.
FQ-CR2 User's Manual
155
Error Table