Table of Contents
Advertisement
2. Cabling
Console Port
The CONSOLE port on the Management Module normally serves as the primary
user interface with the BitStorm 4800 during installation.
Procedure
To connect a terminal or PC to the CONSOLE port:
2-10
1. Configure the terminal or terminal emulation program to use the following
parameters:
— Maximum speed: 9600 bps
— Data bits: 8
— Parity: None
— Stop bits: 1
2. Determine and procure the proper Data Terminal Equipment (DTE) cable type.
The CONSOLE port requires a DB9 plug connector. The other connector
depends on the serial port on your terminal or PC.
3. Connect the DB9 plug connector to the CONSOLE port socket. The
CONSOLE port is ordinarily used only during installation, so do not fasten the
connector.
4. Connect the other end of the cable to the serial port of your terminal or PC.
Serial
Port
April 2002
02-17075
4821-A2-GN20-00
Advertisement
Table of Contents
