Table of Contents
Advertisement
Configuration
Overview
The BitStorm 4800 is designed to require minimal configuration before it can be
accessed by a Network Operations Center (NOC). You may need to configure:
T
T
T
T
Initial configuration can be performed using the Command Line Interface (CLI).
The CLI is available from a terminal or PC connected to the CONSOLE port of the
Management Module.
See the
Conventions Used
In this book, the Enter key means whatever key you use to submit data to your
terminal or PC. It may be called the Return key on older devices.
Characters displayed on your screen, including those you type, are shown in the
Courier font in this book.
4821-A2-GN20-00
The IP address for the Management Module if the default address
(10.10.10.10) is not usable
The default gateway address
The data rate for the V.35/X.21 port, if used
The serial interface type for the V.35/X.21 port if you use an EIA-530-A or X.21
uplink
BitStorm 4800 User's Guide
April 2002
for detailed information about the CLI.
4
4-1
Advertisement
Table of Contents
