Table of Contents
Advertisement
2. Cabling
Power Cord
The BitStorm 4800 can be powered by any AC source providing 90 to 264 VAC at
47 to 63 Hz.
Procedure
To connect the BitStorm 4800 to a power source:
When power is appplied to the BitStorm 4800, the front panel Light-Emitting
Diodes (LEDs) convey the state of the unit and its interfaces. See
LEDs
2-14
1. Verify that the switch on the rear panel is in the Off (0) position.
2. Insert the power cord into the socket under the switch.
3. If the BitStorm 4800 is in a rack, dress the power cord to the left and fasten it
to the rail with a cable tie.
4. Connect the other end of the power cord to a grounded AC power source.
5. Press the On (1) position of the switch to turn on the BitStorm 4800.
.
April 2002
24
R T S 1-
D S L P O
02-17080
Chapter 3,
4821-A2-GN20-00
Advertisement
Table of Contents
