Table of Contents
Advertisement
If the BitStorm 4800 causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will
notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you
believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the
operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
If trouble is experienced with the BitStorm 4800 , refer to the repair and warranty information on Page A. If the
equipment is causing harm to the telephone network, the telephone company may request that you disconnect the
equipment until the problem is resolved.
The user may make no repairs to the equipment.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service
commission or corporation commission for information.
If the site has specially wired alarm equipment connected to the telephone line, ensure the installation of the
BitStorm 4800 does not disable the alarm equipment. If you have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer.
Supplier's Declaration of Conformity
Place of Issue:
Paradyne Corporation
8545 126
Largo, FL 33773-1502
USA
Date of Issue:
3/28/2002
Paradyne Corporation, located at the above address, hereby certifies that the BitStorm 4800, Model Number
4821-AX-XXX, bearing labeling identification number US:AW2HN04B4821 complies with: the Federal Communications
Commission's ("FCC") Rules and Regulations 47 CFR Part 68 and the Administrative Council on Terminal Attachments
("ACTA")-adopted technical criteria TIA/EIA/IS-968, "Telecommunications – Telephone Terminal Equipment – Technical
Requirements for Connection of Terminal Equipment To the Telephone Network, July 2001."
Patrick Murphy
Senior Vice President, Chief Financial Officer
CE Marking
When the product is marked with the CE mark, this demonstrates full compliance with the following European
Directives:
T
Directive 72/73/EEC: Council Directive of 19 February 1973 on the harmonization of the laws of the member
states relating to electrical equipment designed for use within certain voltage limits, as amended by Directive
93/68EEC.
T
Directive 89/336/EEC: Council Directive of 3 May 1989 on the approximation of the laws of the member states
relating to Electro-Magnetic Compatibility (EMC), as amended by Directive 93/68/EEC.
4821-A2-GN20-00
th
Avenue North
April 2002
D
Advertisement
Table of Contents
