Panasonic KX-NCP500 Pc Programming Manual page 289

Private: Use the TIE line service between two or more PBXs.
Maintenance Console Location
3.34 [1-1] Slot—Port Property - T1 Port
Programming Manual References
None
Feature Manual References
9.1.10 INCOMING CALL FEATURES
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
13.1.15 PRIVATE NETWORK FEATURES
CPC Signal Detection (DID)—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming CO line calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
This setting is only available when Channel Type on this screen is set to DID.
Default
160 ms
Value Range
None, 80 ´ n (n=2–75) ms
Maintenance Console Location
3.34 [1-1] Slot—Port Property - T1 Port
Programming Manual References
None
Feature Manual References
3.1.22 CPC (Calling Party Control) Signal Detection
CPC Signal Detection (LCO/GCO)—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming CO line calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
This setting is only available when Channel Type on this screen is set to GCOT or LCOT.
Default
400 ms
Document Version 2009-12
3.34 [1-1] Slot—Port Property - T1 Port
PC Programming Manual 289