Panasonic KX-NCP500 Pc Programming Manual page 13

4. a.
Enter the Installer Level Programmer Code (default: INSTALLER).
Note
There are 2 other Programmer Codes with limited authorization: Administrator Level
(default: ADMIN), and User Level (default: USER). (See 1.2.2 Password Security)
b.
Click OK.
5. Click Connect.
6. a.
Select KX-NCP500/1000 from PBX Model.
b.
Select the LAN or RS-232C tab, depending on the type of PC connection with the PBX.
c.
Specify the settings as required. (See 2.1.1 Starting Maintenance Console and Software
Modes)
Note
When connecting to the PBX for the first time selecting LAN, the IP Address and Port
Number must be set to 192.168.0.101 and 35300 respectively.
d.
Enter the system password for installer (default: 1234).
e.
Click Connect.
7. Follow the instructions of the Quick Setup wizard for the basic items in Quick Setup.
8. On the IP addressing information screen, the information for the IPCMPR card can be assigned
automatically through a DHCP server or entered manually.
Note
If you change any information on this screen and click Apply, the PBX will need to be reset.
When using a DHCP server:
a.
Select Enable for the DHCP Client
setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP
addresses will be assigned automatically
after the PBX is reset.
When not using a DHCP server:
a.
Select Disable for the DHCP Client
setting.
b.
In the IP Address for IPCMPR Card box,
type the IP address of the IPCMPR card.
c.
In the IP Address for VoIP-DSP box, type
the IP address of the DSP card.
d.
In the Subnet Mask box, type the subnet
mask address of the network.
e.
In the Default Gateway box, type the IP
address of the default gateway.
f.
Click Apply.
After Quick Setup is completed, if the IP addressing information was not changed and a
V-IPEXT card was installed during setup, the IP-PT registration screen is displayed. For
information on registering IP-PTs to the PBX, see 3.15 [1-1] Slot—Port Property - Virtual IP
Extension.
You may now begin programming the PBX.
Document Version 2009-12
1.2.1 Installing and Starting the Maintenance Console
*1
*2
*3
*4
PC Programming Manual 13