Panasonic KX-NCP500 Pc Programming Manual page 156

3.14 [1-1] Slot—Card Property - Virtual IP Extension
Signaling (MGCP) UDP Port No. (IP-PT)
Specifies the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-PT side. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
2427
Value Range
1–65535
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Manual References
9.1.15 IP-PT (IP Proprietary Telephone)
Voice (RTP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive RTP (Realtime Transfer Protocol)
data. This must be changed if another network application is using the same port.
For voice communications, the V-IPEXT card uses 64 contiguous UDP ports, starting from the port number
specified here.
To change the value displayed here, click Common Settings and set the desired value.
Default
12000
Value Range
1–65024
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Manual References
9.1.15 IP-PT (IP Proprietary Telephone)
156 PC Programming Manual Document Version 2009-12