Panasonic KX-NCP500 Pc Programming Manual page 231

This column offers two ways to open the screen to select the port command:
•
Click the desired cell in the column.
•
Select the desired cell in the column, and then click Command.
Default
Current status
Value Range
INS: The port is in service.
OUS: The port is out of service.
Maintenance Console Location
3.28 [1-1] Slot—Port Property - LCO Port
Programming Manual References
3.29 [1-1] Slot—Port Property - LCO Port—Connection Command
Feature Manual References
None
Dialing Mode
Selects the type of signal used to dial out to the analog CO line.
Default
DTMF
Value Range
DTMF, Pulse
Maintenance Console Location
3.28 [1-1] Slot—Port Property - LCO Port
Programming Manual References
None
Feature Manual References
4.1.3 Dial Mode Selection
CPC Signal Detection Time—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming CO line calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
Document Version 2009-12
3.28 [1-1] Slot—Port Property - LCO Port
PC Programming Manual 231