Mitsubishi Electric QJ71C24N User Manual page 246

9 UTILITY PACKAGE (GX Configurator-SC)
User frame registration
Data for modem initialization registration
Data for modem connection registration
Modem function system setting
Transmission control and others system setting
MC protocol system setting
Non procedure system setting
Bidirectional system setting
Pre-defined protocol system setting
PLC CPU monitoring system setting
Transmission user frame No. designation system setting
Resetting buffer memory/flash ROM setting values to default values
Flash ROM write allow/prohibit setting
9 - 20
[Setting Items]
The following table lists the selection menus for system setting/registration to be
displayed:
Function
POINT
(1) The ASCII codes are listed in Appendix 4 and GX Configurator-SC's Help
function. Use the list as a reference.
(2) The values set in the respective setting screens explained in Section 9.4 can
be written to the Q series C24 module (via online operation only) or saved to a
file.
(3) Perform the following operations in advance to enable the registration of
setting values in the flash ROM:
(a) Switch setting using the GX Developer (see Section 4.5.2)
Set "Setting change" under [Transmission settings] to "Enable" for both
the CH1 and CH2 sides.
(b) Setting using GX Configurator-SC (see Section 9.4.13)
Set the flash ROM write allow/prohibit setting to "Allowed".
(4) When a multiple CPU system is employed, GX Configurator-SC should be
connected to the control CPU of the Q series C24, and the system setting data
register in the flash ROM.
It is not possible to set target PLC to multiple CPU setting of "Transfer setup"
of GX Developer and register the system setting data in the flash ROM.
Section
Section 9.4.1
Section 9.4.2
Section 9.4.3
Section 9.4.4
Can be used via online
Section 9.4.5
Section 9.4.6
Can be used via offline
Section 9.4.7
Section 9.4.8
Section 9.4.9
Section 9.4.10
Section 9.4.11
Section 9.4.12
Can be used only via online
Section 9.4.13
MELSEC-Q
Remarks
operation.
operation.
operation.
9 - 20