Chapter 6: Ip Interface Configuration; Connecting To The Ipsis; Ipsi Address Configuration - Avaya S8700-Series Installing And Configuring

Chapter 6: IP interface configuration

This chapter covers the following tasks:

Connecting to the IPSIs

l

IPSI address configuration

l
Programming the IPSI for static addressing
l
Setting the VLAN and diffserv parameters
l
Programming the IPSI for DHCP addressing
l
At a minimum, you must program and connect to the reference TN2312BP IP Server Interface
(IPSI) so that the system does not enter No License Mode. Once you connect the IPSIs to the
control network, the IPSIs might generate an alarm if the firmware is not the most current. The
alarm stops automatically once you upgrade the IPSI firmware.
Connecting to the IPSIs
Connect CAT5 cables from the IPSI circuit packs to the dedicated control network or to the
customer LAN.
IPSI address configuration
The IPSI circuit pack receives an IP address:
Statically with static IP addressing, if the control network is nondedicated (public) through
l
the customer network.
Dynamically with dynamic host configuration protocol (DHCP), if the control network is
l
dedicated (private).
Note:
To program DHCP addressing, you must complete certain sequences within a
Note:
predetermined time-out interval. Avaya recommends that you read the following
procedure completely before you start so that you are familiar with these
sequences in advance.
Perform one of the following tasks depending on whether you use static or dynamic addressing:
on page 65
on page 65
on page 66
on page 68
on page 70
Issue 8 May 2009 65