Chapter 6: IP interface configuration
This chapter covers the following tasks:
Connecting to the IPSIs
●
IPSI address configuration
●
Programming the IPSI for DHCP addressing
●
Programming the IPSI for static addressing
●
Verifying connectivity to the media server
●
Verifying that the IPSIs are translated
●
Upgrading the IPSI firmware version (if necessary)
●
Enabling control of the IPSIs
●
Verifying the license status
●
At a minimum, you must program and connect to the reference TN2312BP IP Server Interface
(IPSI) so that the system does not enter No License Mode. Once you connect the IPSIs to the
control network, the IPSIs might generate an alarm if the firmware is not the most current. The
alarm stops automatically once you upgrade the IPSI firmware.
For how to connect the S8500 Ethernet cables, see
page 19.
Connecting to the IPSIs
Connect CAT5 cables from the IPSI circuit packs to the dedicated control network or to the
customer LAN.
Installing and Configuring the Avaya S8500 Media Server
on page 53
on page 54
on page 54
on page 61
on page 62
on page 62
on page 62
on page 59
on page 62
About media server port connections
on
53
February 2007