Accessing The Sat; Logins For Avaya Technicians And Business Partners - Avaya S8700-Series Installing And Configuring

Accessing the SAT

Use a remote Secure Shell (SSH) or terminal emulation session to access the Communication
Manager SAT command line prompt.
Type of connection
Using SAT with SSH:
Using SAT with Terminal
Emulation

Logins for Avaya technicians and Business Partners

Avaya field technicians and Business Partners must use a Services login such as craft or
dadmin to perform initial configuration and upgrades. An Avaya field technician can use a
unique password that is assigned to the customer system.
After the Avaya authentication file is installed, Communication Manager has a password for the
craft login that is unique to the customer system and available when you are connected directly
to the server. If the system is configured without ASG, then all security authentications are
through passwords. If ASG is turned on, then all authentication is through ASG except for logins
over the service port which require a password. The revised password is recorded by RFA and
is obtained from ASG Conversant at 1-800-248-1234 or 1-720-444-5557.
See Accessing the command line interface of the server with
SSH on page 95.
To use a command line interface in a terminal emulation window,
open your terminal emulation application. Configure the terminal
emulation program port settings as follows:
Speed: 115200 baud or 9600 baud if you use a serial
l
modem connection
No parity
l
8 data bits
l
1 stop bit
l
No flow control
l
NOTE: Avaya Native Configuration Manager, Avaya Terminal
Emulation, and HyperTerminal are the only terminal emulation
programs that Avaya supports.
Use either the IP address or the DNS host name to establish a
network connection to the active server. Use port 5023 for this
connection. Use SAT commands on the active server only. When
prompted, log in to the server as craft.
Procedure
Issue 8 May 2009
Accessing the SAT
103