Connecting To The Server Directly - Avaya S8700-Series Installing And Configuring

Connecting to the server directly

To access the server directly, use a computer with the following minimum specifications:
A Windows 2000 or Windows XP operating system
l
32-MB of RAM
l
40-MB of available disk space
l
An RS-232 port connector
l
A network interface card (NIC) with a 10/100BaseT Ethernet interface
l
A 10/100 BaseT Ethernet, category 5 or better, cross-over cable with an RJ45 connector
l
on each end (MDI to MDI-X)
A CD-ROM drive
l
1. Plug one end of the CAT5 cable into the Services access port on the back of the server.
For more information, see
S8730 Server
the S8710 or S8720 Server
2. Plug the other end of the CAT5 cross-over cable into the NIC on your computer. Use a NIC
adapter if necessary.
3. Configure your network connection
IP address: 192.11.13.5
l
Subnetwork mask: 255.255.255.252
l
For specific information, see
page 104.
Once you connect, use a terminal emulation program or a Web browser to administer the
server.
Figure 16: Services laptop computer connected directly to the
on page 98 or Figure 17: Services laptop computer connected directly to
on page 99.
Configuring the network for Windows 2000 and XP
Connecting to the server directly
Issue 8 May 2009
on
97