Post-Upgrade tasks
Note:
Tasks
Note:
server only)
use SAT commands on the active media server.
Restoring the 4600-series IP Telephone configuration file, if any
(main server only)
If you copied a 4600-series Telephone configuration file to the /var/home/ftp/pub directory prior
to the upgrade, you must restore it after the upgrade. However, before you restore the file,
ensure that you have downloaded the appropriate IP telephone firmware.
1. At the Linux command line, type cd ~ftp/pub, and press Enter.
2. At the prompt, type cp 46xxsettings.txt /tftpboot, and press Enter.
The 4600-series IP Telephone settings file is now restored to the /tftpboot directory.
Enabling scheduled maintenance with SAT
To enable scheduled maintenance.
1. Type change system-parameters maintenance and press Enter.
2. Ensure that the administration for the Start Time and Stop Time fields is the same as
before the upgrade.
Busying out previously busied out trunks
If you recorded any busyouts earlier on the main server only, you need to ensure that they also
are busied out after the conversion.
Restoring the 4600-series IP Telephone configuration file, if any (main
on page 115 through
Checking for translation corruption
Post-Upgrade tasks
on page 116
Issue 2.1 June 2006
115