Clean The Heat Exchanger Using The Tool Provided - DeDietrich C 230 ECO Installation And Service Manual

7.3.2

Clean the heat exchanger using the tool provided

The gasket between the inspection trap and the heat
exchanger may stick, as may the one between the burner
and the heat exchanger. Do not tear it
- Remove the nuts from the inspection hatch on the front of the heat
exchanger.
- Remove the inspection trap from the heat exchanger.
- Clean the exchanger with the cleaning tool provided or,
alternatively, with compressed air: rinse with water if necessary.
- The condensates collector can be cleaned by removing the plug
from the top of the collector (before the flue gas discharge pipe)
and rinsing the collector with water.
03/10/2012 - 300015171-001-01 C 230 ECO
53