En Particulier Pour L'allemagne; Mounting; Position Of The Boiler - DeDietrich C 230 ECO Installation And Service Manual

4.3 Mounting

4.3.1

Position of the boiler

Location
C 230 ECO boilers must be installed in a frost-free room.
In order to avoid damage to the boiler, it is necessary to
prevent the contamination of combustion air by chlorine
and/or fluoride compounds, which are particularly
corrosive. These compounds are present, for example, in
aerosol sprays, paints, solvents, cleaning products,
washing products, detergents, glues, snow clearing salts,
etc.
Therefore:
- Do not pull in air evacuated from premises using such
products: hairdressing salons, dry cleaners, industrial
premises (solvents), premises containing refrigeration
systems (risk of refrigerant leakage), etc.
- Do not stock such products close to the boilers.
If the boiler and/or peripheral equipment are corroded by
such chloride or fluoride compounds, the contractual
guarantee cannot be applied.
The warranty does not apply to damage to the boiler caused by these
instances. If the heating device is installed in residential premises
where people are present all the time, it is necessary to use a
concentric ambient air inlet / combustion gas evacuation installation.
When installing the boiler, it is necessary to comply with degree of
protection IP21.
Position of the boiler
The boiler is delivered fully assembled as standard, covered with
plastic wrap, in a pallet crate (70x130 cm), enabling easy handling
with a pallet stacker.
This crate is designed to facilitate handling of the unit and to help in
the positioning of the boiler.
The standard packaging enables access to doors of 745 mm.
The C 230 ECO can be positioned as follows:
- Place the pallet close to the final installation position.
- Remove the packaging.
- Place the boiler in its final position.
03/10/2012 - 300015171-001-01 C 230 ECO
19