Setting The Auto Power Save Mode - Toshiba E-STUDIO477S Advanced Manual

Setting the Auto Power Save mode

1
On the POWER SAVE screen, press [AUTO
POWER SAVE].
The AUTO POWER SAVE screen is displayed.
2
Press the desired period of time (in
minutes) that this equipment should wait
before the Power Save mode is activated.
The Auto Power Save mode setting is completed, and
you will be returned to the previous screen.
Setting the Auto Sleep mode
1
On the POWER SAVE screen, press [AUTO
SLEEP].
The AUTO SLEEP screen is displayed.
2
Specify the following items as required and
complete the setting.
Item name
SLEEP TIMER Press the desired period of time (in
minutes) that this equipment
should wait before the Sleep mode
is activated.
SLEEP MODE Select the AUTO, SLEEP, or
POWER OFF mode after the
specified [SLEEP TIMER] time.
POWER OFF The equipment enters the status
equivalent to shutdown. The
equipment recovers by pressing
the [POWER] button.
AUTO In the following conditions, the
equipment behaves in the same
manner as in the [SLEEP] mode.
• A LAN cable is connected to the
• A Wireless LAN Module is
• A FAX unit is installed
In conditions other than those listed
above, the equipment behaves in
the same manner as in the
[POWER OFF] status.
Description
equipment
installed and enabled
Item name
SLEEP
*1 The target options are as follows:
- Wireless LAN Module
- e-BRIDGE ID Gate
- IPsec Enabler
- Data Overwrite Enabler
*2 The target protocols are IPX/SPX, AppleTalk and so on. For
details, refer to the TopAccess Guide "Chapter 8:
[Administration] Tab Page - [Setup] Item List".
Note
• The equipment may not enter the Sleep mode at the
set timing depending on its operating status.
• The machine is not switched to the Sleep mode in the
following cases:
- A particular option is installed. (Wireless LAN
module, e-BRIDGE ID Gate)
- The IPsec function is enabled.
- IEEE 802.1X authentication is enabled.
- IPv6 is enabled and the IPv6 address is set other
than manually.
- POP3 client setting is enabled and under any of the
following conditions:
- (1) The scan rate is set to other than 0 minute.
- (2) A POP3 server address is entered.
- (3) An account name is entered.
- A particular network protocol is enabled. (AppleTalk,
IPX/SPX)
• Protocol settings for recovering this equipment from
the Auto Sleep mode are made in the TopAccess
administrator mode. For details, refer to the
TopAccess Guide "Chapter 8: [Administration] Tab
Page".
• By default, the Power Save period is set to 1 min and
the Sleep period is set to 1 min.
- 165 -
SETTING ITEMS (ADMIN)
Description
If the following conditions are met,
the equipment is in the SLEEP
mode and only the green MAIN
POWER lamp lights.
Condition 1: Particular options are
*1
not installed
Condition 2: Particular protocols
*2
are disabled
Condition 3: The SECURE
RECEIVE function of the fax
setting is disabled.
To recover, press the [POWER]
button. The equipment recovers
when the print data are received
via the LAN cable or a fax is
received.
In conditions other than those listed
above, the display on the touch
panel is turned off, and the
equipment is in the SLEEP mode
and the green [ENERGY SAVER]
button lights.
To recover, press one of the
following buttons:
• [START], [ENERGY SAVER,
COPY], [e-FILING], [SCAN],
[PRINT], or [FAX]
The equipment recovers from the
SLEEP mode when the print data
are received via the LAN cable or a
fax is received.
1
2
3
4
5
6
7