Setting The Notification; Changing The Administrator Password And Resetting The Service Password - Toshiba E-STUDIO477S Advanced Manual

SETTING ITEMS (ADMIN)

Setting the notification

You can set the notification mail to send a notification message
1 when specified events occur on the equipment, such as paper
empty and service call.
You can specify up to three E-mail addresses for the
destination of the notification message.
Memo
You can specify events that you want to be notified about using
the TopAccess web utility. For instructions on how to specify
2
events for notification, refer to the TopAccess Guide
"Chapter 8: [Administration] Tab Page".
Note
• To enable this function, there must be a SMTP server in
your network. In addition, the settings to enable Internet
communication on this equipment must be configured
correctly.
3
1
On the NOTIFICATION screen, press
[E-MAIL].
4
The on-screen keyboard is displayed.
5
For details of the on-screen keyboard, see the following
page:
 P.227 "On-screen keyboard"
2
Enter the E-mail address and press [OK].
Memo
• You can specify up to three E-mail addresses to which
6
notification messages will be sent, if needed. To
enable notification, you must have at least one E-mail
address entered.
7
3
Press [ON] for the E-mail address to receive
notification, and then [OK].
To disable notification for an E-mail address, press [OFF].
Note
• [ON] is available only after an E-mail address is
entered.
Changing the administrator password
and resetting the service password
You can change the administrator password.
1
On the PASSWORD SETUP screen, press
[ADMIN PASSWORD] or [RESET SERVICE
PASSWORD].
The screen for changing the administrator password is
displayed.
If [RESET SERVICE PASSWORD] has been selected,
the message "Are you sure?" is displayed on the
ATTENTION screen.
Press [YES] to reset the service password.
- 162 -