Terminal Layout - Mitsubishi FX3U-4AD User Manual

FX /FX /FX PLC User's Manual - Analog Control Edition
3G 3U 3UC
FX -4DA (4-channel Analog Output)
3U
3.1

Terminal Layout

The terminals of FX
3.2 Cable and Terminal Tightening Torque
The FX -4DA terminal block is designed for M3 screws.
3U
The end disposal of the cable shown below.
Tighten the terminal to a torque of 0.5 N
• When one wire is connected to one terminal
6.2 mm (0.24")
or less
6.2 mm (0.24")
or less
• When two wires are connected to one terminal
6.2 mm (0.24")
or less
6.2 mm (0.24")
or less
E-10
-4DA are arranged as follows:
3U
Signal
24+
24-
V+
VI-
V+
VI-
V+
VI-
V+
VI-
m to 0.8 N
•
φ3.2 (0.13")
φ3.2 (0.13")
φ3.2 (0.13")
6.3 mm(0.25")
or more
φ3.2 (0.13")
6.3 mm(0.25")
or more
Application
24V DC power supply
Ground terminal
Channel-1 analog output
I+
•
Do not connect any lines.
Channel-2 analog output
I+
• Do not connect any lines.
Channel-3 analog output
I+
• Do not connect any lines.
Channel-4 analog output
I+
m.
•
Terminal
Crimp
screw
terminal
Terminal
'[Žq
Terminal Crimp
screw
terminal
Terminal
3 Wiring
3.1 Terminal Layout