Checking Pilot And Burner Flames - Valor G3 739 Owner's Manual

Checking pilot and burner flames

The pilot light and burner fl ames should be checked
periodically. Check after the fi re has been on for at
least 30 minutes. The pilot fl ame must cover the tip
of the thermocouple probe. The main burner fl ame
pattern will vary depending on the type of installation
and climatic conditions.
Performance of propane gas fi replaces may be
aff ected by the quality of commercial gas supplied
in your area.
The fi replace area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to
ensure that it is not obstructed by snow, trees,
bushes, leaves, or other objects.
Inspect the vent system regularly. We recommend at
least an annual inspection.
Thermocouple
probe must be
739M Pilot
Note
The height and color of your flames can vary
depending on fuel type, fuel quality and
mixture, altitude, and aeration adjustment at or
after installation.
The photos of typical flame appearance are for
illustrative purposes only. Your fireplace may be
operating normally but appear different than
the photos.
Venting configuration, elevation, burner
aeration setting and local fuel heating value can
all affect flame appearance.
16
Typical fl ame appearance—739M
Pilot light
739CLK Classic Logs
Pilot light
739TLK Traditional Logs
Pilot light
739DWK Driftwood Logs
Pilot light
739RSK Rock Set
Pilot light
739LSK Traditional Logs