Furuno FAR-3320W Installation Manual page 85

2.7.2 MC-3010A/3020D/3030D
• MC-3010A: Inputs analog signal. To use MC-3010A as current input, connect short
pins to each terminals.
• MC-3020D: Inputs digital signal (8ch contact input). Contact or voltage input is se-
lectable (contact input requires short pins).
• MC-3030D: Outputs digital signal (8ch, normal open/close).
Fabrications
MC1.5-W-L600/1000/2000/3000 cable
(Input)
30 30
Shield Shield
Vinyl tape Vinyl tape
(fold back) (fold back)
(width: 10) (width: 10)
MC1.5-W-L600/1000/2000/3000 cable
(Output)
30 30
Shield Shield
Vinyl tape Vinyl tape
(fold back) (fold back)
(width: 10) (width: 10)
MPYC-12 cable (MC-3030D)
80 or 80 or
more more
Not used: Cut with 50, Not used: Cut with 50,
and wind tape to insulate. and wind tape to insulate.
TTYCSLA-1 (MC-3010A)
120 120
Core: 6 Core: 6
TTYCS-1 (MC-3010A)
100 100
Core: 6 Core: 6
MPYC-12 cable (MC-3020D)
125 125
85 85
Not used: Cut with 50, Not used: Cut with 50,
Core: 6 Core: 6
and wind tape to insulate. and wind tape to insulate.
80 80
Vinyl tape Vinyl tape
(width: 10) (width: 10)
Pass drain wire through
shrink tubing (local supply),
then attach crimp-on lug
(pre-attached in unit).
80 or 80 or
30 30
more more
Shield Shield
(fold back) (fold back)
Vinyl tape Vinyl tape
(width: 10) (width: 10)
135 135
80 or 80 or
more more
95 95
2. WIRING
60 60
Core: 6 Core: 6
60 60
Core: 6 Core: 6
60 60
Core: 6 Core: 6
2-49