Furuno FAR-3320W Installation Manual page 48

2. WIRING
FAR-3230SW-BB/3300SW
Note: If there is a chance of inclement weather when the RF unit is removed, cover
the intakes on the front and rear covers with packing tape for waterproofing. Be sure
to remove the tape after completing the installation.
Connect the cables as follows:
Note: If there is a chance of inclement weather when the RF unit is removed, cover
the intakes on the front and rear covers with packing tape for waterproofing. Be sure
to remove the tape after completing the installation.
1. Unfasten four bolts to detach the stern cover.
Note 1: The connector for the performance mon-
itor is connected between the stern cover and the
RF-TB Board. Detach the stern cover slowly to
prevent damage to the connector.
Note 2: If the de-icer is to be installed, remove the
bow cover also. Spread open the right and left
heater elements on the cover, then remove the
cover, being careful not to hit the elements on the
radiator or chassis.
2-12
Intake (Cover with packing tape) Intake (Cover with packing tape)
ex) Front side
Intake (Cover with packing tape) Intake (Cover with packing tape)
ex) Front side
Cable for de-icer
Microwave coaxial cable
Serial cable
Antenna motor switch
Performance monitor Performance monitor