Furuno FAR-3320W Installation Manual page 62

2. WIRING
2.4 Processor Unit
Note: The interface ports approved for interconnecting navigation equipment are
shown in the figure below. For details, see section 2.4.3 "How to select the serial input/
output format".
Top view of EC-3000
2.4.1 How to connect cables to terminals in the processor unit
Use screws (M36, supplied) to attach the wiring plate 1 and wiring plate 2 to the pro-
cessor unit. Connect the cables shown below to the connectors at the front of the pro-
cessor unit. Bind cables to the appropriate fixing metal with the cable ties (supplied).
For the cables from the monitor unit, DSUB9P-X2-L5/10M) and ground wire, connect
them to the processor unit directly (without fixing to a wiring plate). Tighten the fixing
screws on these connectors to prevent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
OK
2-26
J8 J8 J8
J5 J5 J5
J3 J3 J3
J11 J11 J11 J6 J6 J6 J9 J9 J9
J4 J4 J4
J13 J13 J13
J10 J10 J10
J7 J7 J7
UP
J3, J4
For IEC 61162-2 or
J12 J12 J12
IEC 61162-1
J14 J14 J14
J5, J6, J7, J8, J9, J10
For IEC 61162-1