Furuno FAR-3320W Installation Manual page 76

2. WIRING
11. Connect the shield wires of the antenna cable and serial cable for processor unit.
12. Reattach the cable clamp assembly.
13. Remove the connector cover for the power cable (2 places).
14. Fabricate the power cable (DPYC-2.5) as shown below.
Armor
15. Pull up the plastic cover and connect the power cable.
16. Remount the connector cover for the power cable.
17. Reattach the cover of the power supply unit.
2-40
Grounding point (for antenna cable) Grounding point (for antenna cable)
Grounding point Grounding point
(for serial cable for processor unit) (for serial cable for processor unit)
Connector cover of power cable
Vinyl tape
Sheath (Clamp here.) Sheath (Clamp here.)
25
35
Plastic cover
FV2-M4
30