2. Detach the performance monitor connector (J807) from the RF-TB board.
3. Unfasten four screws to open the cable entrance cover.
Note: The orientation of the cable entrance assy. can be changed, in one of the
three positions shown below. The default entrance is "deck". No other orienta-
tion is allowed, to maintain watertight integrity. To change the entrance, un-
fasten the four screws circled in the figure below, then orient the cable entrance
assy. in the required direction. Refasten the screws.
Deck entrance
Unfasten these screws to change the orientation of the cable entrance assy.
BOW ►
Mid-stern entrance
TO CHANGE THE ORIENTATION:
J807 (performance monitor)
Stern entrance
2. WIRING
2-7