Furuno FAR-3320W Installation Manual page 46

2. WIRING
5) Coat the gasket (all brims) of the intake with the supplied oil compound. Be
sure to coat the gasket completely.
6) Set the front cover supplied with the kit. Take care not to hit the heater ele-
ments on the chassis or radiator.
7) Coat two M5 screws (supplied) with marine sealant then use them to fasten
the base of the heater. Take care not to hit the heater elements on the chassis
or radiator. Fasten the installation materials shown below to each of the cover
bolts.
8) Attach the supplied earth label over the earth label currently attached near the
grounding terminal.
7. Position the cables so their armors lie beneath their respective cable clamp plates
in the cable entrance. Fasten the plates.
2-10
Intake Intake
Brim Brim
M5 screw coated with M5 screw coated with
marine sealant marine sealant
Earth
label
Hatch: Oil compound
Fixing Fixing
shaft shaft
Grounding Grounding
terminal terminal
M5 screw M5 screw
Cover bolt Cover bolt